Buying Guide

Commercial Saunas and Cold Plunges for Gyms, Studios and Wellness Centers: A Buyer's Guide

HUUM HIVE sauna heater in a commercial sauna room

The best commercial sauna for a gym, studio or wellness center is one built around your daily traffic: a heater rated for heavy use and sized to the room, an electrical service that matches the heater's voltage and phase, benches long enough for your busiest hour, and a cleaning routine your staff can actually keep. Cold plunges follow the same logic. Pick filtration and sanitation that can handle many users, and confirm the warranty covers commercial use. This guide walks through each decision so you can buy once and buy right.

Commercial vs. Residential: What Actually Changes

A home sauna might run a few sessions a week. A gym sauna can run all day, with the door opening every few minutes and a steady stream of sweaty, damp users. That changes almost every part of the buying decision:

  • Heater duty: Heaters marketed for commercial use are built for long run times and frequent door openings. Harvia, for example, groups its Virta, Virta Combi, Virta Pro and Club heaters as its commercial line and describes them as made for heavy usage and easy maintenance.
  • Room volume: Commercial rooms are usually larger, so they need more kW and more stone mass.
  • Electrical service: Commercial buildings may have three phase power or 208V service rather than the 240V single phase common in homes. That affects which heater model you order.
  • Codes and inspections: Commercial projects often face accessibility rules, fire and life safety review, and in some areas health department review. Your local building department sets these, not the equipment maker.
  • Warranty terms: Read the warranty and confirm it covers commercial use before you buy, not after.

Step 1: Plan Capacity Around Your Peak Hour

Start with how many members or clients you expect in the sauna at the same time during your busiest window, not your daily average. Then add room to move. A sauna that is packed at 6 a.m. leads to complaints and propped-open doors, which wastes heat.

Practical ways to plan capacity:

  • Bench length: Measure usable bench length and allow space per person so people are not shoulder to shoulder.
  • Two tier benches: Upper and lower benches let users choose their heat level and add seating without enlarging the footprint.
  • Multiple smaller rooms: Two mid-size saunas can be easier to schedule, clean and keep running than one very large room. If one is down for service, you still have heat on the floor.
  • Infrared suites: Studios that book private sessions often prefer several one or two person infrared cabins, which typically plug into standard outlets. Browse infrared saunas for that model.

For larger group rooms, look at our 5+ person saunas and traditional indoor saunas.

Step 2: Choose a Heavy-Use Heater Sized to the Room

Every electric sauna heater is rated for a range of room volumes, measured in cubic feet. Multiply the room's length, width and height to get the volume, then choose a heater whose rated range covers it. In a busy facility, many builders lean toward the upper part of that range because frequent door openings pull heat out of the room. For a full walkthrough of the math, see our heater kW sizing guide.

Heaters we carry that are built for larger, busier rooms

Heater Rated room size What to know
HUUM HIVE 12 (12 kW) 424 to 636 cu ft Floor mounted, holds 528 lbs of stones. HUUM positions it for health clubs, spas and gyms. Control, extension box and stones sold separately.
Harvia Virta Pro HL160E (16 kW) Up to 918 cu ft Described by Harvia as a choice for heavy-duty use. Control, power extension and stones sold separately.
Harvia Virta HL80E (8 kW) Up to 431 cu ft Floor standing heater from Harvia's commercial line, for mid-size rooms. Control and stones sold separately.
Harvia Virta Combi HL80SA (8 kW) Up to 431 cu ft Combines a heater with a steamer, so one room can offer dry heat or a more humid session.

HUUM also makes the HIVE in 15 and 18 kW versions, and larger HUUM heaters use an extension box with the control. Browse all sauna heaters and accessories, or shop by brand in our Harvia heaters and HUUM collections.

Step 3: Confirm Voltage and Phase Before You Order

Getting this wrong is an expensive mistake. Heaters are built for a specific voltage and phase, and the same heater can be offered in several versions. In our catalog, for example, some Harvia models are listed in both 240V single phase and 208V three phase versions.

Voltage also changes output. HUUM's DROP manual shows that a heater rated 6 kW at 240V produces about 4.5 kW when connected at 208V, with a smaller room range to match. If your building runs 208V and you size from a 240V spec sheet, the room may never reach temperature.

Before you order, have your licensed electrician confirm:

  • The service voltage and phase available at the sauna location
  • Panel capacity for a new dedicated circuit for each heater
  • Breaker size and conductor size from the heater maker's installation manual
  • Where the control and any power or extension box will mount

Our sauna electrical requirements guide covers this in more detail. A licensed electrician must size and install every circuit.

Step 4: Plan Ventilation, Flooring and Finishes for Traffic

  • Ventilation: A busy room needs steady fresh air. A common approach is an intake low near the heater and an exhaust higher on the opposite side, but follow the heater and room maker's instructions. Our ventilation guide explains the basics.
  • Flooring: Choose a water resistant, easy to clean floor. Many facilities add a floor drain so the room can be rinsed.
  • Benches and backrests: Smooth, low-knot wood holds up better to constant contact. Removable duckboards and backrests make deep cleaning easier.
  • Controls: Wall controls with timers and lockouts help staff manage hours and prevent members from changing settings.

Step 5: Cold Plunges for Commercial Use

Many facilities now pair a sauna with a cold plunge. For multi-user settings, focus on these points:

  • Sanitation and filtration: Look for continuous filtration plus a sanitizer such as ozone or UV. The Barton Cold Plunge, for example, uses a 1,200 gallon per hour pump, oversized filters and an ozone system.
  • Chiller capacity: More users means more heat added to the water. Check the chiller rating and the lowest temperature the unit holds. The Barton holds water as low as 39°F with a 1/2 HP chiller.
  • Warranty for commercial use: Confirm it in writing. Cryospring's 1-year Barton warranty includes commercial use.
  • Power and drainage: Many plunges run on a standard outlet, but check the amp draw and plan a GFCI-protected receptacle and a nearby drain.
  • Durability: Rotomolded or stainless tubs, locking lids and covered equipment hold up better around a gym floor.

See every option in our cold plunge collection, and read our cold plunge buying guide for more on chillers and filtration.

Step 6: Build a Maintenance Routine Staff Can Follow

Commercial saunas wear faster simply because they run more. A written routine keeps them safe and looking good:

  • Daily: Wipe benches and backrests, rinse or mop the floor, check that the heater guard and controls are intact.
  • Weekly: Scrub benches, clean the floor drain, check door hinges and handles.
  • Periodically: Inspect and rearrange or replace sauna stones as the heater maker recommends, since stones break down faster with heavy use.
  • Cold plunges: Test water, change filters and refresh water on the maker's schedule.

Our sauna maintenance guide has more cleaning tips.

Step 7: Buying Multiple Units

If you are outfitting several locations or several rooms at once, a little planning saves money and headaches:

  • Standardize models so staff learn one control, one cleaning routine and one set of spare parts.
  • Match each heater to each room's voltage. Two locations can have different electrical service.
  • Coordinate freight. Our saunas ship free by freight to the lower 48. Plan who will receive, inspect and move each delivery into place.
  • Talk to us before you order so we can confirm availability, lead times and the right versions for your building.

Frequently Asked Questions

What size heater does a gym sauna need?

Measure the room's cubic feet and choose a heater whose rated range covers it, leaning higher for a room with heavy door traffic. For example, the HUUM HIVE 12 is rated for 424 to 636 cubic feet and the Harvia Virta Pro HL160E for rooms up to 918 cubic feet.

Can I use a residential sauna in my studio?

Some residential models may work for light use, but check the warranty first and confirm it covers commercial use. For heavy daily traffic, choose heaters and equipment the maker positions for commercial use.

Do commercial saunas need three phase power?

Not always. It depends on your building and the heater you choose. Many heaters come in single phase and three phase versions. Your electrician should confirm what is available before you order.

Are infrared saunas good for gyms and wellness centers?

Infrared cabins suit studios that book private sessions because they are compact and many run on standard outlets. Traditional saunas suit open-access gyms where many people share one hot room.

What should I look for in a commercial cold plunge?

Strong filtration, a sanitizer such as ozone or UV, enough chiller capacity for your traffic, a durable tub and lid, and a warranty that covers commercial use.

Get a Commercial Quote

We help gyms, studios, spas and wellness centers choose saunas, heaters and cold plunges that fit their space, power and traffic. Visit our Trade & Commercial page to start a project, or call us at (737) 377-2909.

Reading next

Golden Designs 2025 Toledo 6 Person indoor hybrid sauna
Golden Designs Reserve Edition 2-person full-spectrum indoor infrared sauna (GDI-8020-03)

Leave a comment

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.